1. During the normal operation of the machine, it is strictly forbidden to open the cover.
2. Do not make dead knots when wiring. (Sleeve with cotton thread, pay attention to the direction of the socket)
3. When lowering the shaft, the number of knots and the number of knots should be marked on the label, so as to facilitate the operation of the next process.
4. For non-emergency stop, do not press the red emergency stop button.
5. Turn off the power after shutdown.
6. When wrapping aluminum foil, the core wire should be completely wrapped by aluminum foil. Usually, the overlap rate of aluminum foil is 27%-30%, and the overlap width is 2-4mm (for special models, refer to the specific requirements of the wire pressing card).
7. The tension of the aluminum foil should be appropriate. If the tension is too large, the aluminum foil will be easily broken. If the tension is too small, the core wire will not be tight and the core will slip.
8. The aluminum foil cannot be wrapped in reverse, and the conductive surface (white bright surface, tested with a multimeter for continuity) must wrap the core wire and the ground wire.
9. The ground wire cannot be wrapped in the middle of the core wire, and should be wrapped around the side of the entire core wire to contact the conductive surface of the aluminum foil.
10. If an abnormality is found in production and cannot be solved by itself, stop the machine immediately and report it to the foreman or technician for processing.
11. When installing the wire eye mold, pay attention to the size that the stranded core wire should not be too tight when passing through. To prevent scratching the core wire.
12. The tension adjustment should be appropriate (too tight), which will cause the inner core wire to be stretched when the outer quilt is intact.
