The scope of application of the stranding machine is very wide. Except for the stranding machine, or the automatic stranding machine, the automatic stranding machine, the general automatic stranding machine can wind coils of different sizes, such as toroidal coils and square coils. There are many kinds of coils, and their winding methods are mainly set differently. Each type of coil must be set with appropriate basic parameters. In addition, the bearing capacity and wire-passing technology must also be adjusted in time, so that the coil can be wound. The coil is suitable for the production process requirements and has a unique appearance.
When the stranding machine winds thin coils, there are generally two types of wiring methods: random wiring and forced wiring. These two arranging methods have their own advantages. Arbitrary arranging depends on the surface tension coefficient of the wire and the swing of the swaying wheel or pendulum to arrange the wire. Each turn of the wire can be tightly wound, so that the wound coil can guarantee the expected effect of "mirror glass", but it is very difficult to adjust, mainly because the industrial equipment industry has too much control. The simultaneous movement of the spool is professional, so that each time it is wound, the servo motor of the cabling mechanism has a certain interval, which is generally the interval of one cable diameter of the servo motor. In today's development of electronic components numerical control technology, it is not difficult to carry out. It is only necessary to set the basic parameters of the winding in advance, and the winding can be done without too much adjustment. However, according to the continuous testing of everyone, it is very difficult to quickly wind the coil within 0.1mm using the forced winding method, and chaos often occurs. circumvent the situation.
1. The line is not neat. It is necessary to analyze in detail whether there is a problem in the normal production process, or the problem formed after the adjustment of the product is changed. The former is generally a system configuration problem. The latter one is generally a setting problem. The system configuration problem is generally the loose fixture tooling, the loose fixing screws of the cable arrangement, and the poor lubrication of the cable arrangement.
2. The parking part of the machine tool spindle is not accurate. The inaccuracy of the parking part of the machine tool spindle is generally caused by the failure of the brake plate. For example, the brake pads of the car are loose, or the brake pads of the car are damaged. It is also related to the setting of the brake plate time. If the brake plate time is too short, the parking part of the machine tool spindle will be strictly prohibited. Always remove car brake pads or. Perform brake pad timing adjustment.
3. The number of winding coils is strictly prohibited, and the number of wire stranding machines is strictly prohibited. Generally, due to the system configuration problems of sensors or controllers, the stranding machine cannot work. Generally, the Dongguan stranding machine manufacturer is notified for maintenance and processing.
